Nothing is more annoying than getting into the groove of flying your drone, only to have to bring it down a minute or two later because your battery is almost dead. A large majority of today’s drones can stay in the air for a maximum of 30 minutes, sometimes only able to be done with …
The post ‘Flying Battery’ Can Last Up to 2 Hours appeared first on Dronethusiast.
In order to meet their massive electricity needs on a daily basis, more countries are moving to renewable energy sources than ever before. Solar and hydropower are both viable solutions to this problem, but harnessing wind energy is something that the United Kingdom is now big on. The Walney Extension has officially taken the title …
The post World’s Largest Offshore Wind Farm Captured by Drone appeared first on Dronethusiast.
Great Website.
I’m a commercial Pilot in the UK but getting my son into fpv racing as it looks a lot of fun!
Keep up the good work on the blog.
All the best.
Regards Scott
https://drone.sdimaging.co.uk/
If I understand it correctly, L9R does not allow any changes to the assignments of channels to the connectors. ch 1-9 are fixed to conventional pins and ch 1-12 are on the single sbus. You could:
A) connect additional devices listening to ch 9-12 on the same Sbus together with your APM 2.6
B) check APM 2.6 if its channel range could be changed to ch 5-12 instead. The same could be don on the Taranis in order to free up ch1-4 for additional devices on the conventional pins of the L9R
Hi, will this work with FrSky L9R?
I am using APM 2.6 with SBUS for CH 1-8, but I’d like to use the rest of the remaining channels in L9R, ch 10-12.
I read about it. It sounds great too. I took part in drone racing from last 1 year. It’s awesome game. Everyone enjoy this game. There are so many companies who arrange drone racing game. Now a days, drone racing trend is growing and so many competition arranged every year.
Hello
I have a drone that had a 8 bit gimbal controller that I replaced with a alexmos 32 bit controller. I use a taranis with a X8R rx. The cable that were connected on the 6 and 7 port of the X8R was connected to the old 8 bit board. The new board has a plug on the PWM/PPM/S-Bus port. I connected the same cable to this input, changed the setting in GUI to futaba s-bus ,but the taranis do not control the gimbal. Any suggestions.