Comment on How to bind X8R to the FrSky Taranis in different modes by Mario v V

Posted by Dronerator

Hello
I have a drone that had a 8 bit gimbal controller that I replaced with a alexmos 32 bit controller. I use a taranis with a X8R rx. The cable that were connected on the 6 and 7 port of the X8R was connected to the old 8 bit board. The new board has a plug on the PWM/PPM/S-Bus port. I connected the same cable to this input, changed the setting in GUI to futaba s-bus ,but the taranis do not control the gimbal. Any suggestions.